Unserious are your source choices my man, everyone can invent their own truth. Not much more to say tbh.

thankfully I do not have cause I actually am an eastern european.

I encourage you to go to Russia and check yourself, maybe ask a few Russians. Hopefully you end up on the frontline pretty fast and stop posting shit like this.

Or at least maybe go to some post-soviet country and ask the elderly how great it was under the communism. Those who survived it of course.

It does have some AIness to it, but I agree with other comments that it is most likely not. Maybe AI enhanced or sth

Ender’s game kinda shit

Polish would probably be “Mieć wyjebane”, which comes from “Mieć wyjebane jajca”. It is also balls-related but more like “I have my balls out for that”.

Fuck Trump and Musk, but seriously, this comic is just shit. Whatever you people call communism in the US has nothing to do with what actual communism was or is. The communism had its elites and whoever claims that people were or are equal under communism is just an ignorant. And, most importantly, communism in Soviet Union was just a brutal regime which silenced the opponents by killing or torturing them.

I see, to be honest I have not checked how clean it actually is. It is visually transparent, as opposed to the used one, but you are probably correct.

What I do is just expose the dirty isopropanol to sun or UV in general - the resin will precipitate. Then just filter it out and you have clean isopropanol.

It’s absolutely not. Median is a value in the middle of a sorted set and average is, well, average. In the set of 1, 7, 10: 7 is median and 6 is average.

They look like air bubbles to me, but it is weird they only come out after the bath. Could be they were already inside, but only covered by a thin wall of resin.

I usually use Isopropanol for bath not Ethanol, so I am not sure how your resin reacts with that. The bath should also be rather short, like 1min or something.

A few things to try:

• If you are shaking your resin before print, then give it like 10 minutes after you pour it into the vat, so all bubbles come out and pop
• lower the print speed
• add wait times between the end of lowering the plate and light on
• try to hollow out the model if possible, so there is less printing volume

say whaaaat. I wanna see it reproduced, but if true this is huge.