Oh wow! I had forgotten all about Carmen. :D

Gotta admit, that took me way longer than it should have.

One day a coworker announced he had bought a PC with the new 80286 processor running at 10 MHz (an unheard of blistering speed).

That afternoon the entire Engineering Department went to his house to look at it.

Please share your future project. I’d love to see a practical use case.

Okay. Now I dare you to count up all the Samsung “Galaxy” products.

WOW! That is super even. I looked at mine with a FLIR attached to my phone, and it had definite hot spots. It might be time for a new heat bed.

I am impressed that the edges of your build plate are hot enough to keep the corners from curling up. This is a problem I fight on any print that is close to an edge.

Damn. I came here to do exactly this!

I laughed WAY too hard at this. The closer I looked, the more detail I saw, the harder I laughed.

Nice article, easy read.

Yeah, there is more going on here than PJRC, Sparkfun or Adafruit are telling us. In no universe does simply cutting off a revenue stream make sense.

I keep seeing the word “drama” thrown around. I suspect it’s not taking place in an online forum, but in the real world.

I don’t like pouring in sand during the print. It’s too easy for the fans to blow it all over.

I use gyroid infill and leave a hole in the bottom. Then pour in casting plaster after the print is removed from the bed. Let dry and sand smooth.

Ahem. That would be an “Ultra Maroon!” https://youtu.be/HuxJqIs2a-Y

Welcome to Iowa.

The headline may be true, but who would know?! My cats have been demented since kittenhood.

Holy crap. The boy on the left could have been me. Check out the huge collar and bell bottoms.

The girl on the right could have been my brother. :D

It’s like finding a new SRV song.

Train nerd here – that would be a “trestle.”

Mystery Men – that beast looks like a Herkimer Battle Jitney!

Aaaand now I have to watch it again!