Yeah. I have a RAIDz2 on super old version of FreeNAS. 8x4TB.

I’ve been needing to upgrade for about a year now. I’ve been waiting for the prices to go lower…. News about WD forced my hand for 8x18TB. Not $$ I was looking to spend, but fomo that my upgrade could now be much further away pushed me to just do it. :(

A surprisingly fun game. It exceeded my expectations. I have played it more than I thought I would.

Once you get it setup, start looking for homeassistant compatible hardware instead. There is a lot. Even some big brands use protocols (zigbee, zwave, matter) that can connect to homeassistant without a need for their hub (granted you do have a HA hub) or cloud connection.

I try to stay away from WiFi if possible, but if home assistant compatible I’ll use it.

Haven’t seen Dead Cells mentioned. Love that game.

That’s amazing. I’m on my own espresso journey. Even knowing all the theory going in, consistent execution can be elusive.

Good luck to you and cheers to great coffee at home.

Adding to this. A pressure cooker brings the cook time down dramatically and I think it produces a superior result.

Doesn’t losing a vdev cause the entire pool to be lost? I guess to your point with sufficient redundancy for new vdev 1 drive redundancy whether 3 disks or 5 is essentially the same risk. If a vdev is added without redundancy that would increase risk of losing the entire pool.

https://archive.org/details/swgrap

Damn you fine

Shithole state

From Frank Herbert’s Dune

Any road followed precisely to its end leads precisely nowhere. Climb the mountain just a little bit to test that it’s a mountain. From the top of the mountain, you cannot see the mountain.

Pretty sure it means “Very Ugly”.

Why doesn’t that joystick have drift!?

There are also redwoods in New Zealand. Redwoods Forest, Whakarewarewa

I don’t know what inspired you to write this, but thank you. It has been over a year and a half since I’ve exercised in any real capacity. Todays plan was to do it today. As the day progressed it kept getting easier and easier to justify doing it tomorrow.

After reading this post it motivated me to push through the excuses and get on the stationary cycle. Thank you.

It has done this since it was installed. I used what was in the box to mount and wire it. It requires a C wire which is available from the furnace. I traced the C wire back to the furnace control board and it’s connected to the C terminal block, but I am definitely not an expert on furnaces.